Corning PC 320 Hot Plate Stirrer
Temperature Range
25C to 500C
Speed Range
60 to 1,100 RPM
Platform Size
6 x 7.5 in (15.2 x 19.1 cm)
Features
- Analog dial controls for precise temperature and stirring adjustments
- Wide temperature range of 25C to 500C for versatile applications
- Stirring speed range of 60 to 1100 RPM with eleven speed settings
- 6 x 7.5-inch white ceramic platform for superior heat retention and scratch resistance
- Bright platform surface enhances sample visibility for better monitoring
- Indicator light provides a clear signal when the hot plate is active
- Durable construction designed for consistent performance in laboratory environments
All of our equipment will be fully tested to perform at factory specifications before being shipped.
INCLUDED:
The Corning PC 320 Hot Plate Stirrer includes:
The Corning PC 320 Hot Plate Stirrer includes:
- Power Cord
- Full 180 Day Parts and Labor Warranty
Corning PC 320 Hot Plate Stirrer Specifications
| Temperature Range | 25°C to 500°C |
| Stirrer Speed | 60 to 1,100 RPM |
| Platform Size | 6 x 7.5 in (15.2 x 19.1 cm) |
| Electrical Requirements | 120V, 60Hz |
Hot Plate Stirrers Inspection and Recertification Checklist
- Inspect Display and Replace Any Dim/Dead Pixels (If Applicable).
- Inspect Ceramic Top for Any Cracks and Replace If Necessary.
- Inspect Functionality of All Buttons/Knobs.
- Use Magnetic Stir Bar Alongside NIST Tachometer to Confirm RPM of Internal Motor (If Applicable).
- Inspect Internal Wiring Inside Case.
- Clean Internal Parts and Vent Any Internal Debris.
- Check Feet to Confirm Plate Sits Properly Balanced.
- Replace All Parts That Were Removed on Internal Inspections.
- Confirm Temperature with NIST Traceable Temperature Probe (If Applicable).
- Ensure Cosmetics Are Acceptable.
Technician Inspection and Recertification Checklist: Hot Plate Stirrers
The Following Checklist Is to Be Performed on All Incoming and Outgoing Equipment| Task | Completed? | Remarks? |
| Inspect Display and Replace Any Dim/Dead Pixels (If Applicable) | Completed | |
| Inspect Ceramic Top for Any Cracks and Replace If Necessary | Completed | |
| Use Magnetic Stir Bar Alongside NIST Tachometer to Confirm RPM of Internal Motor (If Applicable) | Completed | |
| Inspect Internal Wiring Inside Case | Completed | |
| Clean Internal Parts and Vent Any Internal Debris | Completed | |
| Check Feet to Confirm Plate Sits Properly Balanced | Completed | |
| Replace All Parts That Were Removed on Internal Inspections | Completed | |
| Confirm Temperature with NIST Traceable Temperature Probe (If Applicable) | Completed |
102 Tide Mill Road, Hampton NH 03842
customerservice@marshallscientific.com | (603) 601-8511 |
www.marshallscientific.com
Copyright © 2024 by Marshall Scientific LLC. All rights reserved.
