 |
 |
 |
|
VWR Digital Vortex Mixer, Cat. #: 10153-842
The VWR Digital Vortex Mixer, Cat. #: 10153-842 is a high-performance laboratory mixer designed to deliver precise and repeatable results. It operates within a speed range of 500 to 3,000 RPM and features a 4.9mm orbit. This mixer is equipped with a versatile timer that can be set from 1 second up to a substantial 9999 minutes. It stands out for its microprocessor control which consistently maintains the set speed, ensuring a strong and consistent mixing action. The mixer includes intuitive touch pad controls along with independent LED displays for both speed and time, enhancing its ease of use. The timer is not just a countdown device; it also displays elapsed time and, when set to a specific time limit, automatically shuts off the unit once the time reaches zero. Offering two modes of operation (continuous and touch modes), this mixer caters to a variety of laboratory needs.
All of our equipment is in excellent condition and will be fully tested to perform at factory specifications before being shipped.
The VWR Digital Vortex Mixer, Cat. #: 10153-842 includes:
- > Rubber Dimpled Head
- > Power Cord
- > Operator's Manual
- > Full 180 Day Parts and Labor Warranty
VWR Digital Vortex Mixer, Cat. #: 10153-842 Specifications
|
Speed Range
|
500 to 3,000 RPM
|
|
Orbit
|
4.9mm (0.194 in.)
|
|
Timer
|
1 second to 9999 minutes
|
|
Dimensions (L x W x H)
|
7 x 4.4 x 5.3 in. (17.8 x 11.2 x 13.5 cm)
|
|
Weight
|
10 lb. (4.5kg.)
|
|
Electrical Requirements
|
120V, 50/60Hz, 135W, 1.2A
|
- Verify power supply and PCB output correct, stable voltages across all required circuits
- Confirm the correct platform head is installed according to specifications
- Inspect the display for dim or dead pixels, replacing any compromised sections to maintain clear visibility
- Confirm full functionality of all buttons and knobs, ensuring accurate input response
- Verify that touch, pulse, and continuous modes operate fully and as intended
- Inspect all internal wiring for breakages, tears, or wear, replacing any underperforming components to ensure reliability
- Disassemble and thoroughly clean the internal casing to remove any accumulated debris
- Check that the feet are intact and confirm the vortexer is properly balanced on a flat surface
- Conduct a comprehensive cosmetic inspection to ensure all exterior surfaces meet quality standards
Technician Inspection and Recertification Checklist: Vortexer
The Following Checklist Is to Be Performed on All Incoming and Outgoing Pieces of Equipment
|
Task
|
Completed?
|
Remarks?
|
|
Verify power supply and PCB output stable, correct voltages across circuits
|
Completed
|
|
|
Confirm correct platform head is installed according to specifications
|
Completed
|
|
|
Inspect display for dim or dead pixels; replace compromised sections for clarity
|
Completed
|
|
|
Confirm functionality of all buttons and knobs for accurate input response
|
Completed
|
|
|
Verify full operation of touch, pulse, and continuous modes as intended
|
Completed
|
|
|
Inspect internal wiring for damage; replace underperforming components for reliability
|
Completed
|
|
|
Disassemble and clean internal casing to remove accumulated debris
|
Completed
|
|
|
Check feet for integrity and confirm vortexer is balanced on flat surface
|
Completed
|
|
|
Conduct comprehensive cosmetic inspection to ensure quality of exterior surfaces
|
Completed
|
|
To View More of Our Recertification Protocol Click Here
|
|
|
 |
|
 |
|
