Agilent 1100 HPLC System with Variable Wavelength Detector & Fluorescence Detector

The Agilent 1100 HPLC System guarantees the most efficient mixing and pulse-free solvent delivery for consistently fast and accurate results. The system’s optimized design using a quaternary pump allows variable stroke volumes for stable solvent flow. This electronically activated inlet valve runs synchronous to the pistons to eliminate vapor formation in volatile solvent, making the Agilent 1100 both remarkably easy-to-use and maintenance-free. It also features a high-speed proportioning valve and a pre-configured degasser, which allow convenient low-pressure mixing and a large solvent choice flexibility. The HPLC System’s vacuum degasser ensures reduced operating costs without the use of helium and optimum instrument performance.

The Agilent 1100 Variable Wavelength Detector lowers detection limits with simplified optics for high sensitivity, low baseline drift, and wide linear range. This wide linear range allows for reliable simultaneous quantitation of main and side products and impurities. The Agilent 1100 VWD’s minimum baseline noise gives it the highest baseline stability for the lowest detection limits. This VWD offers programmable wavelength switching for sensitivity and optimized selectivity optimized to each analyte’s elution, along with stop-flow wavelength scanning for quick wavelength optimization.

The Agilent 1100 Fluorescence Detector brings high-sensitivity and selection through simultaneous multi-wavelength detection. This easy-to-use detector provides quantitative data and fluorescence spectra from a single run. The FD's spectral information can be used for rapid method optimization and verification of separation quality.

The unit can be operated with a hand-held controller or computer running Clarity software. The HPLC System features extensive diagnostics with compatible data analysis software for on-site and remote trouble-shooting.

All of our equipment is fully tested to perform at factory specifications before being shipped.

Agilent 1100 HPLC System Specifications

Type	Specification
Detection type	Double-beam photometer
Light Source	Deuterium lamp
Wavelength Range	190 - 600 nm
Short term noise (ASTM) Single and Multi-Wavelength	± 0.75 × 10-5AU at 254 nm
Drift	3 × 10-4AU/hr at 254 nm
Linear Absorbance range	> 2 AU (5%) upper limit
Wavelength accuracy	± 1 nm
Slit width	1, 2, 4 , 8, 16 nm
Band Width	6.5 nm typical
Diode Width	< 1 nm
Flow Cell	Standard: 14-µl volume, 10-mm cell path length and 40 bar (588 psi) pressure maximum High pressure: 14-µl volume, 10-mm cell path length and 400 bar (5880 psi) pressure maximum
Control and Data Evaluation	Agilent ChemStation for LC
Analog Outputs	Recorder/integrator: 100 mV or 1 V, output range 0.001 – 2 AU, two outputs
Communications	Controller-area network (CAN), GPIB, RS-232C, APG Remote: ready, start, stop and shut-down signals, LAN optional
Safety and Maintenance	Extensive diagnostics, error detection and display (through control module and ChemStation), leak detection, safe leak handling, leak output signal for shutdown of pumping system. Low voltages in major maintenance areas.
GLP Features	Early maintenance feedback (EMF) for continuous tracking of instrument usage in terms of lamp burn time with user-settable limits and feedback messages. Electronic records of maintenance and errors. Verification of wavelength accuracy with built-in holmium oxide filter.
Housing	All Materials recyclable

Computer Specifications
Model	Dell Optiplex 7050 Desktop PC
Processor	Intel Core i5-6500 Processor 3.6GHz
Ram	16GB
Hard Drive	250GB Internal SSD
Operating System	Windows 10 Professional, 64bit

Agilent 1100 Series HPLC System Operator's Manual