Agilent 1100 HPLC G1315B Diode Array Detector
Light Source
Wavelength Range
Detection Type
Long-life deuterium and tungsten lamps for highest intensity and lowest detection limit over a wavelength range of 190–950 nm,
No loss in sensitivity for up to five wavelengths simultaneous,
Programmable slit from 1–16 nm for complete optimization of sensitivity, linearity and spectral resolution,
Easy front access to lamps and flow cell for fast replacement
Built-in holmium oxide filter for fast wavelength accuracy verification and built-in temperature control for improved baseline stability
The Agilent G1315B DAD is in excellent condition and will be fully tested to perform at factory
specifications before being shipped.
The Agilent 1100 HPLC G1315B DAD Detector includes:
> Firmware Version 07.02 (Can be changed upon request)> Flow Cell> New Agilent UV Lamp> New Agilent Vis Lamp
> G1369 Lan Interface Card (and tech support for interface)
> Calibration Reports> Lab Advisor Calibration Report> Lan Cable / Power Cord> Operator's Manual> Full 180 Day Parts and Labor Warranty
Agilent 1100 HPLC G1315B Diode Array Detector Specifications
Type
Specification
Detection type
1024-element photodiode array
Light Source
Deuterium and tungsten lamps
Wavelength range
190 – 950 nm
Short term noise (ASTM) single and multi-Wavelength
± 1 × 10-5 AU at 254 and 750 nm
Drift
2 × 10-3 AU/hr at 254 nm
Linear absorbance
range
> 2 AU (upper limit)
Wavelength Accuracy
± 1 nm
Wavelength bunching
1 – 400 nm
Slit width
1, 2, 4, 8, 16 nm
Diode Width
< 1 nm
Flow Cells
Standard: 13 µl volume, 10 mm cell path length and 120 bar (1760 psi)
pressure maximum Semi-Micro: 5 µl volume, 6 mm cell path length and 120 bar
(1760 psi) pressure maximum High pressure: 1.7 µl volume, 6 mm cell path
length and 400 bar (5880 psi) pressure maximum 500 nano: 0.5 µl volume, 10 mm
cell path length and 50 bar (725 psi) pressure maximum
Control and data evaluation
Agilent ChemStation for LC
Analog outputs
Recorder/integrator: 100 mV or 1 V, output range 0.001 – 2 AU, two
outputs
Communications
Controller-area network (CAN), GPIB, RS-232C, APG Remote: ready,
start, stop and shut-down signals, LAN optional
Safety and maintainence
Extensive diagnostics, error detection and display (through control
module and ChemStation), leak detection, safe leak handling, leak output
signal for shutdown of pumping system. Low voltages in major maintenance
areas
GLP features
Early maintenance feedback (EMF) for continuous tracking of
instrument usage in terms of lamp burn time with user-settable limits and
feedback messages. Electronic records of maintenance and errors. Verification
of wavelength accuracy with built-in holmium oxide filter.
Housing
All materials recyclable
Great Products 
